Assembling The Slats - BWT myPOOL POOL'N BOX Instrucciones De Montaje

6.3

Assembling the slats

Lay out the ½ slats that constitute the pool widths, then, in the corners, slot in the slats that constitute the
pool lengths. After laying out the first row of slats, make sure that the diagonals are equal.
Fit the slats together, according to the assembly diagram shown in
machined slats correctly (see
downwards.
The female slats and half-slats located on the top of the walls are machined to subsequently
accommodate the liner locking track. The machined section should be oriented towards the inside of
the pool.
While assembling the pool walls, make sure as of the first rows that the slats are fully engaged in the
grooves. After assembling the first row, check that the slats are perfectly level, make any corrections
necessary, then screw the slats constituting the pool lengths together:
• fix them to the 4 supporting braces (these are pre-drilled, as shown in Figure
torx hinge screws 6 × 30 (bag D).
• screw them together as shown in
comprising 10 slats rows of slats, that is a total of 80 countersunk 5 x 40 A4 SS torx screws threaded
over 25 mm (bag C) .
WOODEN POOLS
Figure 6). The tongues should always be oriented upwards, and the grooves
female half-slat
(70 x 45)
female slat
(137 x 45)
male/ female slat
(145 x 45)
female half-slat
(78 x 45)
Figure 8 – Slotting together the wooden slats
Figure 10
Figure 9 – Fastening the slats to the supporting braces
BWT myPOOL POOL'N BOX
Figure 8
using 2 screws per slat pair, and on both sides, each
2021/02 - Version: D Code : 37311
and taking care to position the
9) using the 36 A2 SS
19/48