Introducing The Filter Medium; Installing The Pressure Gauge; Mounting The Diffuser - BWT myPOOL POOL'N BOX Instrucciones De Montaje

Caution: avoid using excess glue, this could damage the ball in the valve. You may handle the lid after
glueing, but be careful not to touch the unions, and in particular, do not twist the valve.
7.2.2 Introducing the filter medium
Screw in the drain plug, do not forget
the o-ring.

7.2.3 Installing the pressure gauge

Place the o-ring in its groove in the lid. Orient the
pressure gauge and place it in its housing.

7.2.4 Mounting the diffuser

WOODEN POOLS
Check that the collector plate
is correctly positioned at the
bottom of the filter tank. Insert
the collector pipe (topped with
its plug) into the hole in the
middle of the collector plate.
Centre the diffuser in its housing, and push it firmly against the lid,
twist it to slide the tongue of the diffuser fully into the U shaped
groove in the lid.
BWT myPOOL POOL'N BOX
Carefully pour 20 kg of sand
into the filter and spread it out
with your hand.
Working from underneath the lid, screw
the bronze nut by hand and then using a
22 wrench, moderately to avoid damaging
the o-ring .
2021/02 - Version: D Code : 37311
27/48