Installation Of The Filtration System; Abs Fittings; Skimmer - BWT myPOOL POOL'N BOX Instrucciones De Montaje

7.

INSTALLATION OF THE FILTRATION SYSTEM

7.1

ABS fittings

When mounting the ABS fittings, do not over-tighten, this could fracture the parts.

7.1.1 Skimmer

Mount the grey tube, external diameter 60 mm, length 34 mm, on the skimmer body at the location
circled in red in Figure
it in its vertical position against the wooden wall.
Next, slide the skimmer into the purpose made cut-out in the top slat. The front part of the skimmer should
be flush with the inner pool wall.
Place the wooden cleat (in red in
skimmer in position. Fasten the bracket and the cleat to the wall using:
• 6 countersunk screws 5.5 × 25 A4 SS (bag of screws enclosed with the skimmer) for vertically
oriented screws, inserted from above,
• 4 hinge screws 6 × 20 A2 SS torx (bag G), for horizontally oriented screws.
Figure 22 – Mounting the wedge on the skimmer
WOODEN POOLS
Figure 20 – Pine trim
22. Push it in fully, but do not use glue. This tube will wedge the skimmer, holding
Figure 23), and the metal bracket over the skimmer to block the
BWT myPOOL POOL'N BOX
Figure 21 – Protective adhesive
tape
Figure 23 – Mounting the skimmer bracket
2021/02 - Version: D Code : 37311
25/48