Installation; Moving The Machine - NAMCO TIME CRISIS 4 DX Manual Del Operador

3. MOVING THE MACHINE

l
This equipment is fitted with castors to make it easier to move. Take care when
moving the equipment on an inclined floor.
l
The overall height of this equipment is 2340mm. Take care of any overhead
obstructions. (e.g. Light Fittings, Electric Cables etc.)
l
Before moving, ensure that the game is seperated into 3 parts: Header Assy,
Monitor Cabinets and Gun/Coin Assy.

4. INSTALLATION

Notes on Installation
l
NEVER turn the power to the machine ON until installation has been completed
l
In order to prevent possible electric shocks, be sure that the machine is
connected to the mains supply with a securely connected earthed plug.
l
So that customers are not injured, ensure that there is at least 500mm
separation between other machines or walls.
In order to avoid damage to the machine due to mis-operation, ensure that the voltage
of the mains supply is 230volts AC.
•
NOTE
•
Preventing Cross Talk
If machines using the same gun detecting system are installed side by side, cross talk may
occur between them resulting in machine malfunction. If machines of the same type are to
be installed side by side, make sure that they are alternately ' Frequency Change connector '
installed Game PCB and ' Frequency Change connector ' not installed Game PCB models.
The ' Frequency Change Connector' is fitted to the Player 2 Game PCB.
32
If the location site of this machine has a polished floor, it is
recommended that rubber pads are fitted under the level adjusters to
prevent the machine sliding on the floor.
In order to gain access to the Power Supply and CPU assemblies,
ensure that the rear of the machine is separated from a wall or other
machine by at least 500mm