Safety Warning; General Safety Considerations - NAMCO TIME CRISIS 4 DX Manual Del Operador

No part of this publication may be reproduced by any mechanical, photographic or electronic process, or in the
form of phonographic recording, nor may it be stored in a retrieval system, transmitted or otherwise copied for
private use, without permission from NAMCO EUROPE LIMITED.
While the information contained in this manual is given in good faith and was accurate at the time of printing,
NAMCO EUROPE LIMITED reserve the right to make changes and alterations without notice.
This equipment has been manufactured in accordance with European Directives, and has been tested and
complies with the directives 89/336/EEC and 72/23/EEC by the application of EN55014-1, EN55014-2 and
EN60334-2-82 standards and as such bears the CE marking. Any changes or modifications to this equipment
must be in accordance with the European Directives. Any unauthorised changes to this equipment may
contravene such directives.
Under some conditions of extreme external interference, e.g. radio transmissions, electrostatic discharge or mains
born transients, some degradation of performance may occur. However the equipment will recover normal
performance once the source of interference has ceased or been removed.
Following abnormally high surges on the mains supply, the video monitor may need to be manually reset by
turning the equipment OFF and back ON.
If the game processor resets due to an interruption of the mains voltage, any credits established will be lost.
This equipment is not a machine as defined by the machinery directive 89/392/EEC.
In order to use this equipment safely, be sure to read this Operators Manual carefully before installation,
adjustment or use of this equipment.
Whenever the owner of this equipment entrusts dis-assembly, installation, adjustment or routine maintenance to
another person, the owner should ensure that that person read the appropriate precautions and relevant sections
of this manual before starting work.
In order that no accidents occur when the equipment is in operation, strictly follow the notes on safety as
described below.
This manual along with the Installation Manual (where applicable) form an integral part of the equipment and must
be available to the operating or service personnel at all times.
This equipment is for indoor use only and should only be used for the purpose intended.
Namco Europe Ltd. bears no responsibility for accidents, injury or damage resulting from unauthorized changes
to, or improper use of this equipment.
The following safety notes are used throughout this manual. Familiarize yourself with each of these notes and it's
meaning before installing, servicing or making adjustments to this equipment.
WARNING l Warning denotes a hazard that could result in injury or death. Do not proceed beyond a warning
note until the indicated conditions are fully understood and met.
CAUTION Caution denotes a hazard that could result in damage to the equipment. Do not proceed beyond
a caution note until the indicated conditions are fully understood and met.
l Only operate this equipment after checking that it has been installed correctly and in accordance
with this manual.
l
The warning notices must always be kept in good condition and replaced if worn, so that customers
can read them clearly.
l
Installation, service, adjustment or routine maintenance should be carried out by suitably qualified
persons only.
l
For continued protection against fire hazard, replace fuses with the same type and rating. The use of
other fuses or material is prohibited.
l The power supply inside the monitor will remain hot and have areas of high voltage even though the
equipment has been tuned OFF, and there is the possibility of burns or electric shock. Be careful not
to touch these areas.
l To prevent possible electric shock due to failure, this equipment MUST be fitted with a securely
connected EARTHED plug.
l
If at any time the mains lead becomes damaged, it must be replaced immediately.
l
Do not turn the power switch ON until the equipment has ben installed correctly.
Before connecting the machine to the mains supply, ensure that the equipment is set for the correct voltage
and that the correct fuse are fitted.
6

SAFETY WARNING

SAFETY NOTES

GENERAL SAFETY CONSIDERATIONS