Installation; Joining The Monitor Cabinet And Control Assy; Adjusting The Level Adjusters - NAMCO TEKKEN 5 SUPER DX Manual Del Operador

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
3.

INSTALLATION

3-1

Joining the Monitor Cabinet and Control Assy

1.
Slide the Control Assy up to the Monitor Cabinet, taking care not to trap any
wires.
2,
Fit 2off hex head screws, with flat washer.
3.
Connect the connectors.
3-2

Adjusting the Level Adjusters

1.
When the game is in it's final position lower the six (6) (4off Monitor Cabinet, 2off
Control Assy), Level Adjusters,with a spanner, so that all castors are raised from
the floor by approximately 5mm. Tighten the lock nuts with a spanner to ensure
that the Level Adjusters do not move.
Note:
If the site of this game has a smooth or polished floor, it is recommended that
rubber pads are fitted under the Level Adjusters to prevent the game sliding on
the floor when in use.
Lock Nut
Level adjuster
Page 30
Hex head screw
(with Flat washer)
Castor
Approx. 5mm
Tabla de contenido
loading

Tabla de contenido