Replacing The Cross Pc Board - NAMCO TIME CRISIS 4 DX Manual Del Operador

7-13 Replacing the CROSS PC Board

•
The CROSS PC Board can be damaged by static electricity.
Before handling the CROSS PC Board, always touch an earthed metal surface to
discharge any static electricity.
1. Remove the 4off torx screws (M5x12) and remove the Joint Cover.
2. Disconnect the two connectors, remove 4off pozi heads screws (M3x6), with flat and
spring washers, and remove the CROSS PC Board.
Torx screw (M5 x 12)
Joint cover
Torx screw (M5 x 12)
Pozi head screw (M3 x 6)
(with both flat and spring washers)
Joint Assy
CROSS PC board
3. Reassemble in reverse order.
Note: After reassembly, check the communication condition
88
Connector
(see 6-2-3 page 56)