Description Of The Symbols; Important; Machine Composition - OEM SUPERTOP Manual De Uso

SUPERTOP - SUPERTOP VARIO
General specifications and warning
- The machine and its safety components have been
manufactured in compliance with the directives indi-
cated in the declaration of conformity.

1.3 - DESCRIPTION OF THE SYMBOLS

Many accidents are caused by a poor knowledge of
and by a non compliance with the safety regulations
to put into practice during the functioning and main-
tenance works to be done on the machine.
In order to avoid any accidents, read understand
and follow all the warnings and cautions contained
in this booklet and those written on the plates located
on the machine.
To identify the safety messages included in this book-
let, following symbols have been used:
DANGER
This symbol is used in the safety messages
contained in the booklet in case of potential
danger situations or possibility to cause
serious injuries or dead.
ATTENTION
This symbol is used in the safety messages
of the booklet for any danger situation that,
if disregarded, may cause small or moder-
ate injuries or damages.
The message can be used also in case of
danger situations that may cause damages
to the machine.

IMPORTANT

This symbol is used in case of precaution-
ary measures to be taken in order to avoid
any operation that may reduce the life of the
machine or for important communication to
the operator.
DANGER
For clarity reasons, some illustrations of
this booklet show the machine without
safety guards. DO NOT USE THE MACHINE
WITHOUT SAFETY GUARDS.
This symbol indicates that it is mandatory
to read the instructions for use and main-
tenance before using the device.
This symbol is placed on the parts of the
machine that reach a high temperature.
It indicates the danger of burns.
This symbol is placed next to a special ter-
minal and it indicates that the machine must
be connected to an equipotential network.

1.4 - MACHINE COMPOSITION

Manufacturer's machines are the results of a consider-
able experience.
• vens can be fitted with one single, two or three
chambers, digitally operated.
• If requested by a customer, a smo e e tracting it
can be positioned on the rear or upper side of the
oven and can be controlled by operating the control
board of the oven.
• The oven s is are placed on a bearing base equipped
with wheels.
EN - 5