Nonin WristOx2 Manual Del Operador página 16

Displays, Controls, and Indicators
Activation Switch
This switch is located next to the sensor port.
Pressing this switch activates the Bluetooth radio for 3 minutes.
It can also be used to turn the device on when it is in Standby
mode. See "Activation Switch" section for more information.
Sensor Fault Indicator
This indicator displays if the device determines a sensor fault
exists (e.g., sensor disconnect, misalignment, or incompatibility
with the device). It also displays when the finger is removed from
the sensor.
Pulse Strength Indicator
A pulse strength indicator displays when the device is recording
data. The number bars on the display depends on the pulse
strength as determined by the oximeter.
Full and Partial Display Mode – This heart-shaped indicator is
Full and Partial
followed by up to nine curved bars and displays next to the pulse
Display Mode
rate.
Memory Volume (MVI) Display Mode – This indicator consists
of up to nine curved bars and displays next to the minutes of
Memory Volume
stored data. For more information, see "Memory Volume (MVI)
Display Mode
Display Mode" on page 14.
Poor Pulse Signal Indicator
This indicator displays when the pulse signal is inadequate or
the device does not sense a pulse. It may also display if there is
excessive motion at the sensor site.
8