Operating Height - Nogueira SOFT 600 Manual De Instrucciones

To check the correct measure before cut the PTO, align the machine gearbox
with tractor axle, according to fig.6-1. Thus preventing the measure be
inadequate to raise or lower the machine when operating.
ATTENTION
NOTE:
Cut the both pieces, the solid part and the tubular part must be the same length.
There must be a minimum distance of play 25 mm on both ends of the driveshaft.
The instructions for cutting, lubrication, and maintenance are found in a pamphlet supplied by the
manufacturer and fastened to the driveshaft. It is the exclusive responsibility of the authorized
Nogueira dealer to prepare and install the driveshaft and the first test run of the machine.

Operating height

In order to perform the best spreading, there must be a 75 cm height from the ground to the Soft disc.
fig.6-1
SOFT 600 / 900
CUT
CUT
fig.6-2
17