Leveling; Preparing And Installing The Driveshaft - Nogueira SOFT 600 Manual De Instrucciones

Leveling

In order to guarantee uniform spreading, it is necessary to operate the machine leveled. Leveling is
performed by using the hydraulic arms of the tractor.

Preparing and installing the driveshaft

Due to the varying distance between the tractor power take-off and the SOFT spreader actuation axle
in diverse models of existing tractors on the market, eventually, it may be necessary to adjust the
length of the driveshaft before using it. In this case, the machine must be properly coupled to the
tractor and the power take-off must be disconnected, then proceed in the following manner.
- Separate the two parts of the driveshaft;
- Couple the tubular part (female) in the SOFT spreader axle and the solid part (male) in the tractor
power take-off;
- Place the two parts (male and female) side by side. Check if there is a minimum distance of play of 25
mm in the two ends of the driveshaft. (If the necessary play is not present, then mark the ends, so that
the driveshaft can be cut);
- Remove the driveshaft from the machine and the tractor and cut the ends;
- Assemble both parts of the driveshaft. Check to see if the cross pieces are aligned;
- Couple the tubular part (female) to the solid part (male) in the tractor power take-off.
25 mm
play
16
Instructions Manual
KEEP THE END
ALIGNED