Mettler Toledo IND570 Manual De Instalación página 97

2.4.6.9. PROFIBUS PLC Option (Harsh Enclosure)
The PROFIBUS PLC option board (Figure 2-115) is installed in position 3 (Figure 2-94) on the
main board. Connection to the PROFIBUS board in the harsh enclosure (Figure 2-115) is made
using a right-angle nine-pin connector inside the IND570 enclosure. This connector is a standard
Siemens part # 6ES7 972-0BA12-0XA0 or equivalent. It is not supplied by METTLER TOLEDO.
There are two nine-pin connectors on the PROFIBUS board – use the connector and cable routing
shown in Figure 2-116. Refer to Figure 2-114 for the PROFIBUS nine-pin connector assignments
and follow the wiring instructions included with the connector to terminate the wires.
2-64 METTLER TOLEDO IND570 Terminal Installation Manual
Pin Signal
1 Not used
2 Not used
3 RxD/TxD +
4 RTS
5 GND bus
6 +5V bus
7 Not used
8 RxD/TxD -
9 Not used
Figure 2-114: PROFIBUS Nine-Pin Connector Assignments
Figure 2-115: PROFIBUS Option Board for Harsh Enclosure
NOTES:
1. USE MATING CONNECTORS AND CABLE
RECOMMENDED FOR PROFIBUS
CONNECTIONS.
2. REFER TO PROFIBUS INTERNATIONAL
DOCUMENTATION FOR OTHER
CONSIDERATIONS.
30205319 | 11 | 07/2019