ENGLISH
- Assemble the backets C on the square
tube of the roller frame, and at this point
the roller is ready to be assembled on
the machine, lift it and place it at the
rear of the machine already assembled
on the tractor. Fix the two upper blades
A by means of the bolts N and the two
bottom blades F with the bolts and the
spacer M.
Also consult the diagram in fi gure 15
when the roller is being assembled (it is
also given on a decal affi xed to one of
the two roller links on the machine).
3.4 MOBILE BODY SIDES
The mobile body sides are safety ele-
ments and, during the operation, they
must penetrate the ground for atleast 15
mm. If worn out, they must be replaced.
They can be adjusted in height by means
of bolts A (Fig. 16).
3.5 HITCHING TO THE
TRACTOR
WARNING
Before hitching the implement to the
tractor, make sure that this latter is a
suitable type.
Test especially the distribution weight
on anterior axle of tractor (see technical
data on the table «TAB. 2 - TECHNICAL
DATA»).
Place the machine on level ground and
reverse with the tractor at a minimun dis-
tance of 1m. (Fig. 17) from the machine.
Switch off the engine, activate the park-
ing brake, therefore to descend from the
tractor and to link the lower connnections
BD - BE - BF
ROTODENT BD - BE - BF - RM - RK - RmaX
ESPAÑOL
fi jándola inferiormente en ella sobre el
agujero G, y de la parte superior sobre
el agujero P.
- Montar los estribos C sobre el tubo
cuadro telar del rollo, a este punto el
rollo está listo para el montaje sobre
la máquina, levantarlo y posicionarlo
detrás de la máquina en precedencia
aplicada al tractor. Fijar las dos hojas
superiores A. con los pernos sobre el
agujero N y las dos hojas inferiores F
con los pernos más distancial sobre el
agujero M.
En las fases de montaje del rodillo,
consultar también el esquema de la fi g.
15 (presente también en el adhesivo
aplicado en la máquina en uno de los
dos brazos rodillo).
3.4 COSTADOS MÓVILES
Los costados móviles laterales son com-
ponentes de seguridad, cuando se trabaja
deben penetrar en el terreno por lo menos
15 mm. Si se consumen deben sustituirse,
pueden ser reguladas en altura mediante
los bulones A (Fig. 16).
3.5 ENGANCHE CON
EL TRACTOR
ATENCIÓN
Antes de enganchar el implemento en
el tractor, controlar que este último
resulte compatible para su conexión.
Controlar sobre todo el peso sobre los
ases y, si es necesario, lastrar anterior-
mente el tractor, (cerciorarse en el ta-
blero «TAB. 2 - DATOS TECNICOS»).
Con la máquina situada en un llano, acer-
RM
Fig. 16
RM - RK - RmaX
33