Electromechanical/Digital Ovens; Alarms During Operation In Electromechanical/Digital Ovens; Alarm For Damaged Or Disconnected Temperature Feeler; Electromechanical/Digital Oven Self-Cleaning Cycle - OEM PRATICO C641 Manual De Uso Y Mantenimiento

5.9 - ALARMS DURING OPERATION IN ELEC-
TROMECHANICAL/DIGITAL OVENS
During the oven functioning, alarms due to breakage
could occur; such alarms are displayed.
5.9.a - Alarm for damaged or disconnected tempe-
rature feeler
When this alarm intervenes, following visual display
appears:
• An automatic cutoff of the power supply to electric
resistances occurs.
• Switch off the oven, wait until it is cool, then try to
start it again; in case the alarm conditions still occur,
contact manufacturerʼs technical service.
5.10 - ELECTROMECHANICAL/DIGITAL OVEN
SELF-CLEANING CYCLE (Fig. 8)
• At the end of each working day, a self-cleaning cycle
shall be carried out before cutting off the oven.
• Press the key or
to reach a 400°C temperature.
• Adjust ceiling capacity at 100% by operating the
the hand grip (1) or the key
key (3) or (4) (in case of ovens with digital
control elements).
• Adjust the bedplate capacity at 100 % by operating
the hand grip (5) or the key
key (3) or (4) (in case of ovens with digital
control elements).
• Leave the oven on for approximately twenty minutes,
then disconnect it to allow it to get cold.
5.11 - TURNING OFF ELECTROMECHANICAL/
DIGITAL OVENS
• At the end of each working day, cut off the oven by
pressing the push-button
• In the event the extractor hood is functioning, let it
function for the time needed to carry out a self-cleaning
cycle.
• On restarting, the oven starts according to the data
being which were present before cutting it off.
EN - 24
and operate the key
(2) as well as the
(6) as well as the
.
C641 - C642 - C643
FIG. 8
3
PRATICO
Functioning
1
5
2
4
6