Putting The Machine Into Service; Instructions For Use; Starting The Engine; Starting The Machine - Grillo G131 Manual De Instrucciones

1) Check that the machine has not been damaged during the transport.
2) Fill with grease the machine PTO flanging all around the coupling (fig. 3 no. 7).
3) Select driving handlebar position according to the use, walking tractor or sickle bar, by using the
two levers (fig. 2 no. 2 and fig. 2 no. 11).
4) Mount wheels and implement (e.g. rotary tiller, plough etc.) and tighten the securing nuts
completely (fig. 3, no. 7).
5) Add engine oil; please refer to the attached instruction booklet.
6) Check gearbox oil (fig. 4); use only MP 80W 90 oil, or international equivalent API GL5 oil, US
MIL-L-2105D, quantity 2,8 litres.
7) Add oil into the air filter and use the same oil type as the engine oil (fig. 5).
8) Insert the control levers (fig. 2) for the walking tractor version, the levers are supplied with the
standard model. The motormower version has different control levers (fig. 3B) to be ordered with
frontal implements and attachments.
9) Verify the tyre pressure according to the table provided:
5.00-12
6.5/80-12
10) For the versions with electric starter verify the battery voltage: it must not be lower than 12V,
when required charge the battery. Charge the battery with a battery recharger set at 12V on slow
charge for 2 hours. Caution: failure to follow this rule may cause deterioration of the battery.
IMPORTANT! During assembly take care not to get the polarity of the battery reversed.
11) Check the clutch wire has a 3/5 mm clearance between the regulator and the lever.
12) Fill the tank with fuel using a funnel provided with a fine filter.
13) Check liquid levels when the machine is horizontal.

STARTING THE ENGINE

1) Push the throttle lever to the halfway position.
2) Move the supplementary Diesel oil lever as shown in the engine manual.
3) Press the decompressor lever (see engine manual).
4) Plug the key in the dashboard pressing it fully down until the red light is on, and turn it for a few
moments until the engine has started. Let the engine warm up for some time before starting work
and do not strain the machine too much during the first 50 working hours, in order to facilitate a
good running-in.

STARTING THE MACHINE

Insert the desired gear by moving the lever no 13 (fig. 2); also choose fast or slow speeds by
moving the lever no 3 (fig. 2). The machine will start by depressing the lever A and the
subsequently on the red lever no. 2 until it comes into position 1 (fig. 6). By releasing the red lever
the machine will stop but the engine will keep running, while the lever turns back to position 2 (fig.
6). To turn the engine off, turn the handle (fig. 7).
If the machine does not move, check that wheels lock release no. 19 (fig. 3) is turned forward.
Please note that on the walking tractors it is impossible to engage reverse speed and rotary hoe
simultaneously mowing due to a safety device. The P.T.O. must be disengaged before engaging
the reverse gear.
Translation of the original instructions

PUTTING THE MACHINE INTO SERVICE

TYRE PRESSURE
2 PLY RATING
2 "

INSTRUCTIONS FOR USE

"
0,90 BAR
1,0 "