Safety Precautions - Philips LBB 3530/00 Instrucciones De Uso

DCN Discussion System
U.S.A. models only - Section 810 of the National
Electrical Code, ANSI/NFPA No.70-1981, provides
Eng
information with respect to proper grounding of the
mount and supporting structure, grounding of the coax
to a discharge unit, size of grounding conductors,
location of discharge unit, connection to grounding
F
electrodes, and requirements for the grounding
electrode.
20. Lightning - For added protection of the units during a
lightning storm, or when it is left unattended and
D
unused for long periods of time, unplug it from the wall
outlet and disconnect the cable system.This will prevent
damage to the unit due to lightning and power-line
surges.
E
FCC and ICES INFORMATION
(U.S.A and Canadian Models only)
WARNINGS - This equipment has been tested and found
NL
to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules and ICES-003 of
Industry Canada.These limits are designed to provide
reasonable protection against harmful interference when
I
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this
equipment in residential area is likely to cause harmful
interference in which case the user will be required to
correct the interference at his own expense. Intentional or
unintentional changes or modifications not expressly
approved by the party responsible for compliance shall not
be made. Any such changes or modifications could void the
user's authority to operate the equipment.
If necessary, the user should consult the dealer or an
experienced radio/television technician for corrective
action.The user may find the following booklet prepared by
the Federal Communications Commission helpful: "How to
identify and Resolve Radio-TV Interference Problems".This
booklet is available from the U.S. Government Printing
Office, Washington, DC 20402, Stock No. 004-000-00345-
4.
ALL SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. INFORMATION FURNISHED BY PHILIPS COMMUNICATION
& SECURITY SYSTEMS. (PCSS) IS BELIEVED TO BE ACCURATE AND RELIABLE. HOWEVER, NO RESPONSIBILITY OR LIABILITY IS
ASSUMED BY PCSS FOR ITS USE, NOR FOR ANY INFRINGEMENTS OR PATENTS OR OTHER RIGHTS OF THIRD PARTIES
WHICH MAY RESULT FROM ITS USE. NO LICENSE IS GRANTED BY IMPLICATION OR OTHERWISE UNDER ANY PATENT OR
OTHER RIGHTS OF PCSS
© 1997 by Philips Electronics N.V. All Rights Reserved.
Philips® is a registered trademark of Philips Electronics North America Corporation. Marca(s) Registrada(s).
© 1997 All rights strickly reserved.
Reproduction by third parties in any form is strickly forbidden, unless prior written authorisation has been given. In the continuing
quest for product improvement Philips reserves the right to change the specification of any article or system without prior notice.
Instructions for use

SAFETY PRECAUTIONS

CAUTION: TO REDUCE THE RISK OF ELECTRICAL
SHOCK, DO NOT OPEN COVERS. NO USER
SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE
PERSONNEL.
This label may appear on the bottom of the unit due to
space limitations.
The lightning flash with an arrowhead symbol,
with an equilateral triangle, is intended to alert
the user to the presence of uninsulated
'dangerous voltage' within the products enclosure
that may be of sufficient magnitude to constitute
a risk of electric shock to persons.
The exclamation mark within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
Warning: To prevent fire or shock hazard, do
not expose units to rain or moisture.
Attention: Installation should be performed by
qualified service personnel only in accordance
with the National Electrical Code or applicable
local codes.
Power Disconnect: Units with or without
ON-OFF switches have power supplied to the
unit whenever the power cord is inserted into
the power source; however, the unit is
operational only when the ON-OFF switch is in
the ON position.The power cord is the main
power disconnect for all units.
ii