Operation; Turning On The Unit/Starting A Firing Program; Designing And Starting Your Own Firing Program - DENTSPLY Multimat Easy Manual De Instrucciones

6 Controls
‹ Turning on the unit/Starting a firing program
1. Turn on the unit with the on off key. The controller will
be started and performance self-test.
2. The main menu will be shown, indicating the program
last run.
3. Move the firing platform down using the Í key. Place
the firing object with firing base and firing support on the
firing platform.
4. If you wish to start the program currently shown, press
the start stop key. The green LED will be lit.
‹ Designing and starting your own firing program
Note: If you try to enter a parameter outside the valid
range (see "Firing parameters"), you will hear a long beep
tone, and the cursor will jump to the parameter you need
to change. You have 60 seconds to enter each parameter.
1. The main menu is shown.
2. Press the P key. The program number will be activated.
Enter the desired program number via the keypad or the
+ and – keys.
3. Press the 4 key. The cursor will jump to the next field,
Pre-heating temperature. Enter the desired value via
the keypad or the + and – keys.
4. Press the 4 key. The cursor will jump to the next field,
Heating rate. Enter the desired value via the
keypad or the + and – keys.
5. Press the 4 key. The cursor will jump to the next field,
Pre-set firing temperature. Enter the desired value via
the keypad or the + and – keys.
52
MultimatEasy
Degudent KBO
V1.00 ...booting.. .
Selftest