Nouvag TCM3000BL Instrucciones De Uso página 57

TCM 3000 BL - Morcellator
5. Replacing seals
Remove the seal unit from the gear unit by rotating it
slightly.
Unscrew the membrane screw from the seal unit.
Check seals before use. Do not use damaged seals (frayed, discolored, yellowed, porous, non-elastic).
Position the edge of the roof shaped seal (1) to point to
the inside stop (2) of the seal holder (3) and press the
roof shaped seal in.
Position the edge of the membrane seal (4) to point to
the slot (5) of the membrane screw (6) and press the
membrane seal into the slot.
Screw the membrane screw (6) into the thread of the
seal holder (3) to the stop and connect the seal unit to
the gear unit.
6. Inserting Obturator
Insert the Obturator through the seal unit, gear unit
and protective tube to the stop.
7. Attaching handle
Lift and hold the release lever (1) of the handle (2).
Push the handle (2) over the motor connection of the
gear unit.
Release the handle release lever. The handle release
lever must lock in position.
Do not open the handle release lever to remove the handle during the procedure.
8. Connecting motor
Insert the motor coupling into the bottom end of the
handle.
Continue to insert the motor until it locks into the gear
unit's motor connection.
Align the red dot on the device connection plug of the
motor with the red dot on the motor connection of the
control unit.
Plug the motor device connection plug into the motor
connection of the control unit. The plug must lock in
position.
Instrucions for use for TCM 3000 BL - Morcellator, Ref. 31946, V26/16
6
1
3
5
2
1
EN
4
2
13