QJMOTOR SRK 400 Manual Del Usuario página 43

of failure. If a bulb of different wattage rating is used,
overload of circuit system and premature failure of
bulb may be caused.
LED light sources are used for the front combination
lights, rear combination lights and turn signal lights
of this model. Though the LED light sources are not
easily damaged, please contact the maintenance
department of dealer for replacement assistance if
required.
ABS operation and maintenance instructions
After turning on the power lock, it is normal that the
ABS indicator on the dash board will be on (not
flashing). The ABS indicator on the dash board will
go out after the riding speed reaches 5km/h, and at
this time the ABS is in normal working state.
If ABS light is on (not flashing), it means that ABS is
in a diagnostic state.
If ABS light goes out, it means that ABS is in normal
working condition.
If ABS light is flashing; it means that ABS light is in
non-working state (or failure).
If ABS indicator keeps flashing, it means that ABS is
in non-working state, please check whether ABS
plug-in is in place, and whether the gap between
ABS wheel speed sensor and ring gear is within the
range from 0.5 to 1.5mm.
If the ABS wheel speed sensor is damaged, ABS
indicator on the dash board will flash and will not
work. ABS wheel speed sensor may attract some
metal substances due to certain magnetic proper-
ties, and it may be damaged in case foreign objects
are adhered, hence the ABS wheel speed sensor
should be keep clean and free of foreign objects.
Please contact maintenance department of dealer
in time in case of ABS system failure.
Storage Guide
Storage
If it is to be stored for a long time, certain mainte-
nance measures must be taken to reduce the
impact of long-term storage of the motorcycle on its
quality.
1. Change the oil.
2. Lubricate the driving chain.
3. Empty the fuel tank and fuel injection unit as
much as possible.
38