Trumpf TruTool N 350 Manual Del Usuario página 13

Contents
1 Safety................................................. 13
2 Product description ............................ 15
3 Operation ........................................... 17
4 Consumables and accessories.......... 20
5 Troubleshooting ................................. 20
6 Repair ................................................ 21
7 Declaration of conformity ................... 22
8 Warranty ............................................ 22
9 Disposal of old power tools and elec-
tronic devices..................................... 22
1 Safety
1.1 General safety instructions
WARNING
Read all safety warnings, instruc-
tions, illustrations and specifica-
tions provided with this power tool.
Failure to follow all instructions listed
below may result in electric shock, fire
and/or serious injury.
Save all warnings and instructions
u
for future reference.
1.2 Additional safety instructions
DANGER
Electrical voltage
Danger to life due to electric shock
u Before each use, check the plug, ca-
ble, and power tool for damage.
WARNING
Danger of hand injuries due to
sharp blades or edges
Do not reach your hand into the pro-
u
cessing section.
Wear protective gloves.
u
WARNING
Chips fly out of the chip ejector at
high speed
Danger of injury due to hot and sharp
chips
Wear protective equipment.
u
Translation of the original operator's manual
WARNING
Danger of injury or property dam-
age due to use of third-party acces-
sories
Only use original TRUMPF acces-
u
sories.
ATTENTION
Property damage due to excessive
power supply voltage
Make sure that the power supply volt-
u
age matches the details on the power
tool's nameplate.
1.3 Symbols
The following symbols are important for
reading and understanding the operator's
manual. The correct interpretation of the
symbols helps to operate the power tool
properly and safely.
Symbols Description
Type of nibbler, e.g.
N 350
TruTool N 350 (3A1)
(3A1)
Power tool with power cable
Power tool with speed controller
Lubrication
Cleaning the surface
Inspection
Loosen / tighten the hexagon-
head screw
Loosen / tighten the slotted
screws
EN
13