Safety Notes; Functional Description; Technical Data; English | 7 - Trumpf TruTool N 160 E Instrucciones De Montaje

Safety Notes

Safety Warnings for Nibblers
Read all safety warnings and all
instructions. Failure to follow the warn-
ings and instructions may result in elec-
tric shock, fire and/or serious injury.
Additionally, the general safety warnings
either in the enclosed leaflet or in the centre
of these operating instructions must also be
followed.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Always wait until the machine has come to a
complete stop before placing it down. The
tool insert can jam and lead to loss of control over
the power tool.
Never use the machine with a damaged
cable. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables increase
the risk of an electric shock.
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with
internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it
should be cut off and an appropriate plug fitted in
its place by an authorised customer service agent.
The replacement plug should have the same fuse
rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be
inserted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a
residual current device (RCD) with a rated residual
current of 30 mA or less.

Functional Description

While reading the operating instructions, unfold the
graphics page for the machine and leave it open.
Intended Use
The machine is intended for cutting sheet metal with-
out deforming the material and is suitable for straight
cuts, cut-outs and narrow curves.
3 609 929 B93 • 2.8.10
Product Features
The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 On/Off switch
2 Die holder screw
3 Punch
4 Die holder
5 Die
6 Rubber ring for knurled screw
7 Knurled screw for die
Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.

Technical Data

Nibbler
Rated power input
Output power
Stroke rate at no load n
Stroke speed under load
Max. steel sheet cutting
capacity*
Cutting width
Smallest curve radius
Weight according to
EPTA-Procedure 01/2003
Protection class
2
* to 400 N/mm with reference to steel sheet
The values given are valid for a nominal voltage [U] of 230 V.
For different voltages and models for specific countries, these
values can vary.
Noise/Vibration Information
Measured sound values determined according to
EN 60745.
Typically the A-weighted sound pressure level of the
product is 79 dB(A). Uncertainty K=3 dB.
The noise level when working can exceed 80 dB(A).
Wear hearing protection!
Vibration total values (triax vector sum) determined
according to EN 60745:
Vibration emission value a
2
K < 3 m/s .
The vibration emission level given in this information
sheet has been measured in accordance with a stand-
ardised test given in EN 60745 and may be used to
compare one tool with another. It may be used for a
preliminary assessment of exposure.
The declared vibration emission level represents the
main applications of the tool. However if the tool is
TruTool
N 160 E
W
W
-1
min
0
-1
min
mm
mm
mm
kg
2
= 9 m/s , Uncertainty
h

English | 7

350
160
2200
1600
1.6
5
40
1.7
/ II