Oregon 410-230 Manual De Instrucciones página 7

410‑230 / 410‑230A
Troubleshooting
Follow the instructions given in the "Stopping" section before you start
to work on the machine.
Problem
Probable cause
One of the safety devices
of the system to which
the machine is connected
has tripped (fuse,
The machine fails to
circuit breaker, etc.)
start when you switch on
(switch in position "I").
The machine is not
plugged into the
mains properly.
The lamp fails to switch
on when the switch is The lamp has blown.
turned to position "I".
The wheel is broken
or damaged.
The grinder is not
secured correctly.
The motor unit is
not secured correctly
to the base unit.
The machine vibrates
abnormally.
The vise assembly is
not secured correctly
to the base unit.
The grinding wheel is
not fitted correctly in
its seat on the hub.
Contact a skilled technician if you are still unable to restore the correct operation
of the machine following the instructions given in the chart.
574412ad_410-230_GrinderManual_EU.indb 7
Illustrated Parts List
See illustration
Solution
572119
Reset the safety device.
537411
If the safety switch trips 522688
again, do not use the
machine, but contact
32677
a skilled technician.
32681
Unplug and plug in
572522
again properly.
572202
572203
Replace the lamp.
572524
35590
Replace wheel.
572525
Check its attachment and,
32678
if necessary, tighten the
securing screws correctly.
581321
Tighten the related
572526
blocking handle correctly.
295387A
572527
Tighten the related
blocking handle correctly.
572529
Dismantle the grinding 105538
wheel, check its integrity
and fit again correctly.
537409
572528
582332
49 .
No.
Description
1 Complete vise assembly
2 Chain stop vise assembly
3 Chain stop
4 Chain stop (5-pack)
5 Pawl center spring kit (5-pack)
6 Adjustment knobs kit
7 Lever vise assembly chain locking
8 Vise jaws
9 Vise locking kit
10 Spring
11 Scales
12 Spring and ball kit (2-pack)
13 E-motor, switch, cables kit
14 End motor cap
15 Switch
16 Spring arm return
17 Bracket arm support
18 Handle kit
19 Motor flange kit
20 Plastic shield
21 Light bulb
EN
7
6/26/17 2:44 PM