Idiomas disponibles
Idiomas disponibles
j)
Make sure that the saw blade is installed to ro-
tate in the proper direction. Do not use grind-
ing wheels, wire brushes, or abrasive wheels
on a table saw.
Improper saw blade installation or use of accesso-
ries not recommended may cause serious injury.
Safety instructions for the handling of saw blades
1.
Only use insertion tools if you have mastered their
use.
2.
Observe the maximum speed. The maximum
speed specified on the insertion tool may not be
exceeded. If specified, observe the speed range.
3.
Observe the motor / saw blade direction of rota-
tion.
4.
Do not use any insertion tools with cracks. Sort out
cracked insertion tools. Repairs are not permitted.
5.
Clean dirt, grease, oil and water off of the clamping
surfaces.
6.
Do not use any loose reducing rings or bushes to
reduce holes on circular saw blades.
7.
Make sure that fixed reducer rings for securing the
insertion tool have the same diameter and have at
least 1/3 of the cutting diameter.
8.
Make sure that fixed reducer rings are parallel to
each other.
9.
Handle insertion tools with caution. They are ide-
ally stored in the originally package or special con-
tainers. Wear protective gloves in order to improve
grip and to further reduce the risk of injury.
10. Prior to the use of insertion tools, make sure that
all protective devices are properly fastened.
11. Prior to use, make sure that the insertion tool
meets the technical requirements of this electric
tool and is properly fastened.
12. Only use the supplied saw blade for cutting wood,
never for the processing of metals.
13. Use the correct saw blade for the material to be
processed.
14. Use only a saw blade with a diameter that matches
the specifications on the saw.
15. Use only saw blades that are marked with an equal
or higher rotational speed than that marked on the
power tool.
16. Use only saw blades recommended by the manu-
facturer which conform to EN 847-1, if intended for
cutting wood or similar materials.
17. Wear suitable personal protective equipment,
such as:
– Hearing protection;
– Protective gloves when handling saw blades.
18. Only use saw blades recommended by the manu-
facturer which conform to EN 847-1.
Warning! When changing the saw blade, ensure
that the cutting width is not smaller and the width
of the saw blade disc is not greater than the thick-
ness of the riving knife!
19. When sawing wood and plastics, avoid the saw
teeth overheating. Reduce the feed speed in order
to avoid the plastic melting.
20. Please note that complex non-through cutting op-
erations and tapered cuts are not permitted.
21. Avoid bevel ripping on bevelling side of the saw
blade.
22. Make sure when mounting or when installing the
parallel stop that it should be aligned parallel to
the the saw blade.
7.
Technical data
AC motor
Power consumption
Operating mode
Idle speed
Carbide saw blade
Thickness of saw blade disc
Number of teeth (pre-mounted
saw blade)
Riving knife thickness
Min. size of workpiece
W x L x H
Min. table size
Max. table size
Cutting height max. 45°
Cutting height max. 0°
Tilting saw blade
Extraction connection
Weight
Technical changes reserved!
*S1: Continuous operation with constant load
www.scheppach.com
220 – 240 V~
2000 W
S1
4500 min
1
255 x 30 x 2.8 mm
1.8 mm
24
2 mm
10 x 50 x 1 mm
742 x 640 mm
1195 x 640 mm
58 mm
83 mm
0 - 45°
Ø 35 mm
approx. 29 kg
GB | 41
