Scheppach HS100S Traduccion Del Manual De Instrucciones Originale página 36

6. Technical Data
AC motor
Performance
Operating mode
Idle speed
Hart-metal blade
Number of teeth
Thickness riving knife
Table size
Cutting height max. 90°
Cutting height max. 45°
Height adjustment
Saw blade swivel
Suction port
Weight ca.
* Operating mode S6 25%: Continuous operation
with intermittent loading (playing time 10 min). En-
gine protection of to hot warming up:
It´s allowed to run the engine with nominal power
maximum 25% of playing time. After this the ma-
chine must run 75% of playing time steadily with-
out load.
Noise values
The total noise values determined in accordance with
EN 62841.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
Wear hearing protection.
The effects of noise can cause a loss of hearing. Total
vibration values (vector sum - three directions) deter-
mined in accordance with EN 62841.
36 | GB
220-240 V~ 50Hz
S1 1800W
S6 25% 2000W
5000 min
-1
ø 250 x ø 30 x 2,8 mm
24
2 mm
563 x 583 x 28 mm
85 mm
65 mm
0 - 85 mm
0 - 45°
ø 35 mm
19 kg
94,0 dB
3 dB
107,0 dB
3 dB
www.scheppach.com
7. Before starting the equipment
• The equipment must be set up where it can stand se-
curely. Use the holes on the inner side of the frame
legs for this.
• All covers and safety devices have to be properly
fitted before the equipment is switched on.
• It must be possible for the blade to run freely.
• When working with wood that has been processed
before, watch out for foreign bodies such as nails
or screws, etc.
• Before you press the ON/OFF switch check that the
saw blade is fitted correctly. Moving parts must run
smoothly.
• Before you connect the equipment to the power sup-
ply make sure the data on the rating plate are denti-
cal to the mains data.
• Connect the machine to a properly installed protec-
tive contact socket, with at least 16A circuit breaker.
8. Attachment and operation
Important! Pull out the power plug before carrying
out any maintenance, resetting or assembly work
on the circular saw.
Place all parts supplied on a flat surface. Grouping
equal parts.
Note: If compounds with a bolt (round head / or hexa-
gon), hex nuts and washers are backed up, the washer
must be fitted under the nut.
Insert screws each from outside to inside. Secure con-
nections with nuts on the inside.
Note: Tighten the nuts and bolts during assembly only
to the extent that they can not fall down.
If you tighten the nuts and bolts prior to final assembly,
final assembly can not be performed.
8.1 Mounting the bench extension (fig. 5)
1. Turn the saw and place it on the floor with the
bench facing down.
2. Align the bench extension (8) flush with the saw
bench (1).
3. Push table extension (8) onto the sawing table (1)
using the hex bolts (19) and cross member (21c).
Repeat for the opposite side.