Scheppach HS100S Traduccion Del Manual De Instrucciones Originale página 40

11. Transport
1. Turn off the power tool before any transport and
disconnect it from the power supply.
2. Apply the power tool at least with two people, do
not touch the table extensions.
3. Protect the power tool from knocks, bumps and
strong vibrations, such as during transport in ve-
hicles.
4. Secure the power tool against overturning and
sliding.
5. Never use the safety devices for handling or trans-
porting purposes.
12. Maintenance
m Warning! Prior to any adjustment, maintenance or
service work disconnect the mains power plug!
12.1 General maintenance measures
- Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible. Wipe
the equipment with a clean cloth or blow it down with
compressed air at low pressure.
- We recommend that you clean the equipment imme-
diately after you use it.
- Clean the equipment regularly with a damp cloth and
some soft soap. Do not use cleaning agents or sol-
vents; these may be aggressive to the plastic parts
in the equipment. Ensure that no water can get into
the interior of the equipment.
- In order to extend the service life of the tool, oil the
rotary parts once monthly. Do not oil the motor.
- Clean the dust collection systems by blowing out
with compressed air.
12.2 Brush inspection
- In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician. Im-
portant. The carbon brushes should not be replaced
by anyone but a qualified electrician.
12.3 Overload switch
The device motor is protected against overload with an
overload switch (11a).
In the event of the nominal current being exceeded, the
overload switch (11a) switches the device off.
If this happens, proceed as follows:
- Let the device cool down for several minutes.
- Press the overload switch (11a).
40 | GB
- Switch the device on by pressing the green "I" but-
ton.
Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consum-
ables.
Wear parts*: carbon brush, table inlay, push rod, saw
blade
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
13. Storage
• Store the device and its accessories in a dark, dry
and frost-proof place that is inaccessible to children.
• The optimum storage temperature is between 5 and
30˚C.
• Store the electrical tool in its original packaging.
• Cover the electrical tool in order to protect it from
dust and moisture.
• When the sawblade and key are not in use, they can
be stored as in figure 23.
• Store the operating manual with the electrical tool.
14. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies with
the applicable VDE and DIN provisions.
The customer's mains connection as well as the
extension cable used must also comply with these
regulations.
• The product meets the requirements of EN 61000-
3-11 and is subject to special connection conditions.
This means that use of the product at any freely se-
lectable connection point is not allowed.
• Given unfavorable conditions in the power supply
the product can cause the voltage to fluctuate tem-
porarily.
• The product is intended solely for use at connection
points that
a)do not exceed a maximum permitted supply im-
pedance "Z" (Zmax. = 0,346 Ω), or
www.scheppach.com