Dräger Polytron Repeater WirelessHART 6700 IR WL Manual Del Usuario página 53

Byte Bit Description
16 0 OUT_OF_SERVICE
1 INSTALLATION_CALIBRATION
2 FAULTS_SENSOR
3 FAULTS_ELECTRONICS
4 M: Maintenance required
5 O: Out of specification
6 C: Function Check
7 F: Failure
17 4 PROGRAM_FLOW_ERROR
19 2 DEV_CONFIG_CHECK
Instructions for use |
Dräger Polytron
Cause
Start sequence active.
Start sequence failed.
Adjustment or bump test active.
Sensor defective.
Incorrect power supply setting (battery or wired).
Serious device error.
–
–
–
–
Error in electronics.
Error in electronics.
®
6700 IR WL, Dräger Polytron
Remedy
Wait for start sequence.
A Wait up to 15 minutes for the start sequence to
complete.
B Restart the device.
C Check the condition of the battery. Test with new
battery pack.
D Contact DrägerService.
E (if applicable) complete or repeat gas library
update.
Finish adjustment or bump test.
A Restart the device.
B Check the condition of the battery.
C Contact DrägerService.
A Check the setting of the power supply.
B Restart the device.
C Reset device to factory settings.
D Contact DrägerService.
–
–
–
–
A Restart the device.
B Reset device to factory settings.
A Reset device to factory settings.
B Contact DrägerService.
® ®
Repeater WirelessHART
| en
Troubleshooting
53