Motorola IMPRES 2 Guia Del Usuario página 61

Charger Troubleshooting
Table 23: Troubleshooting: Normal Charging
Issue
Pocket LED does not
flash Green for
approximately 1
second for charger
power-on.
Battery or radio is
inserted into the
pocket, but the pocket
LED remains OFF and
the battery is not
identified on the
adjacent display.
Flashing Red
LED and
Display (if
available) shows:
NOT CHARGEABLE
REMOVE& REINSERT
or a Motorola
Solutions battery is in
the pocket, but the
Display (if available)
shows:
UNKNOWN
BATTERY
Alternating
Red/
Green LED
at the end of
calibration.
Make sure that the power cord is securely plugged into the
charge and an appropriate AC power outlet.
Make sure that there is power to the outlet.
Inspect fuses and replace as necessary.
If the pocket is not Pocket #1 and Power Saver is enabled,
press a Menu button.
See below.
Remove the battery or radio from the pocket.
Check electrical contacts on the battery and in the charger
pocket for contamination, corrosion, or physical damage.
Verify that the battery is an authorized Motorola Solutions
battery. Other batteries may not charge.
Clean the battery electrical contacts using a dry cloth.
Remove power from the charger, then clean the pocket
electrical contacts using a dry cloth.
Try replacing the battery. If the fault no longer exists, then take
the faulted battery out of service.
If the fault persists with the replacement battery, take the
charger out of service.
The IMPRES 2 or IMPRES battery may be nearing End of
Service. The battery is usable, however the available capacity
may not be suited for heavy use over an extended shift.
Applicable only for APX NEXT XN battery: Battery has been
exposed to high temperature for more than 10 minutes. It is
recommended to remove battery from service.
58
What to do...