Idiomas disponibles
Idiomas disponibles
All the disassembled parts must remain soaking in the sanitizer for the time indicated by
the producer, before they are rinsed with plenty of cold drinking water.
-
Never use any type of solvents and/or thinners to preserve the plastic parts and
gaskets during washing.
25 - ENGLISH
• Emerge the components disassembled previously
into the tank with the sanitizer and brush the
surfaces with care. Pay special attention to the inner
duct of the beater shaft.
REMOVING AND CLEANING THE TAP
• Unscrew the ring nut of the tap (A).
• Pull the split pin from the tap body (B).
• Turn the knob ant-clockwise until the entire shutter is
pulled off the body C.
• Emerge the previously disassembled components
into the tank with the sanitizer and brush the
surfaces with care. Pay special attention to the inner
duct of the tap, to the holes and seats of the OR.
SANITISING FIXED PARTS
While the removable parts soak in the sanitizer
inside the tank, proceed sanitising the fixed parts of
the machine:
SANITISING THE TANK
• Emerge a disposable paper cloth in the sanitizer.
• Pass the cloth over all the surfaces of the tank and
fixed transmission shaft.
• Pass the cloth over the outer edge of the tank until
reaching the surfaces of the cap and front panel.
• Use the brush previously emerged in the sanitizer to
thoroughly clean the drain duct which connects the
tank to the threaded flange of the tap.
