Idiomas disponibles
Idiomas disponibles
If the beater motor runs according to the wrong sense, the pump of the bain-marie circuit
will subsequently get the same incorrect rotation, with consequent loss of fluid (mono-
ethylenic glycol) from the circuit itself.
In this case (loss of glycol fluid) check the relevant level inside the tank and, if necessary,
restore the correct quantity.
• Operating temperature should be between 15° and 35°C.
• Humidity should be between 30 and 60%.
FRIGOMAT s.r.l. will not be held liable for personal harm and/or damage to objects
deriving from incorrect installation and/or by failure to comply with work accident-
prevention standards. Never intervene on the machine with your hands, neither during
normal operating cycles nor during cleaning and maintenance, without first having stopped
the machine by pressing the STOP button and having turned off the master switch. Never
clean the appliance using a high-pressure water jet. Never shut the water cut-off cock
while the machine is running. Be careful never to damage the power cable. If so, have it
replaced.
Machines with water cooling which are left in places at a temperature below or close to
0°C, must first have all the water drained from the condenser.
11 - ENGLISH
2.Condesation pressure (water cooling, only).
Push
simultaneously
AUTOMATIC buttons to activate the compressor
motor. After a few seconds condensation water must
come out of the drain pipe at a temperature of about
35°C. If this is not the case, the pressure switch valve
shown in the figure must be adjusted.
the
STOP
and
SEMI-
