Idiomas disponibles
Idiomas disponibles
ASSEMBLY
l Insert an axle through the middle of a wheel, washer,
and the frame as shown.
l Push a hitch pin into the axle until the center of the pin
rests against the top of the axle.
l Repeat these steps to install second wheel.
CONNECTING THE BATTERY
See Figure 11.
A quick-connect battery cable is pre-installed on the
battery. Remove the cable tie securing the plugs then
push firmly to connect them.
NOTE: The generator is equipped with a battery
charging feature. Once the engine is running, a small
charge will slowly recharge the battery.
RAISING/LOWERING THE HANDLE
See Figure 12.
l Stand in front of the unit, grasp the handle firmly and lift
it to the raised position.
l With the handle in the raised position, the generator
can safely be rolled from one position to another. For
information regarding transporting the unit in a vehicle,
refer to the Transporting section in Operation.
l To lower the handle, gently guide the handle to the
down position.
CAUTION
place your hand or fingers between the handle and
the generator's frame.
WARNING
product unless instructed to so in this manual or
by the manufacturer. Do not use attachments or
accessories that are not recommended for use with
this product. Making unauthorized modifications
and using incompatible accessories can damage
the unit and void your warranty.
OVERVIEW
This portable generator can provide power to a wide
range of items including household appliances, job-site
tools, camping equipment, tailgating essentials, and
much more.
NOTICE
BEEN SHIPPED WITHOUT OIL. Do not attempt
to crank or start engine before it has been properly
serviced with recommended oil. Failure to add
engine oil before starting will result in serious
engine damage that is not covered under warranty.
Pinch point hazard. Do not
Do not alter or modify this
THIS
GENERATOR
FIG. 11
A - Quick-connect battery cable
FIG. 12
A
HAS
A - Handle
A
English | 17
