Machine Assembly - GGP ITALY SPA 325 Manual De Instrucciones

6
EN

4. MACHINE ASSEMBLY

IMPORTANT
The machine is supplied
with some of the components disassembled and
the fuel tank empty.
WARNING!
Always wear strong work
gloves to handle the cutting devices. Mount
the components very carefully so as not to
impair the safety and efficiency of the
machine. If in doubt, contact your dealer.
1. COMPLETING THE MACHINE
1a. "MONO" models (Fig. 1)
WARNING!
The purpose of the spac-
er (1) is to ensure a minimum distance betwe-
en the rear handgrip and the front one, for
safety reasons. This spacer must always be
fitted and must not be modified in any way.
– In front of the spacer (1), fit the front handgrip
(2) onto the drive tube (3) using the screws (4)
and nuts (5) inserted in their proper seatings.
– Before tightening the screws (4), align the
handgrip correctly with respect to the drive
tube.
– Fully tighten the screws (4).
1b. "DUPLEX" models (Fig. 2)
– Put the handlebar (1) into the seating in the
support (2), located on the drive tube (3), mak-
ing sure that the controls are on the right.
– Fit the cap (4), fully tightening the screws (5).
– The support (2) is already preassembled on
the drive tube (3) so that the edge matches up
with the arrow (6) on the label; this position
must never be changed.
2. FITTING THE GUARDS
WARNING!
Each cutting device is
provided with a specific guard. Never use
guards other than those indicated for each
cutting device.
All manuals and user guides at all-guides.com
• 3 or 4-point blade (Fig. 3)
and fit the blade guard.
– Remove the blade (if fitted) as described in
– The guard (1) is fixed to the angle transmission
• Cutting line head (Fig. 4)
line head the additional guard, with line cut-
ting knife, must always be fitted.
– Remove the blade (if fitted) as described in
– The guard (1) is fixed to the angle transmission
– Fit the additional guard (4), inserting the cou-
3. REMOVING AND REFITTING
devices or ones homologated by the Manu-
facturer.
• 3 or 4-point blade (Fig. 5)
and fit the blade guard.
left-hand thread and so must be unscrewed in a
clockwise direction and screwed up anticlock-
wise.
– Insert the wrench supplied (2) into the specific
MACHINE ASSEMBLY
WARNING!
Wear protective gloves
paragraph 3.
(2) by two screws (3).
WARNING!
When using the cutting
paragraph 3.
(2) by two screws (3).
plers into the respective seatings in the guard
(1) and pressing until a click is heard.
THE CUTTING DEVICES
WARNING!
Use only original cutting
WARNING!
Wear protective gloves
NOTE
The cup screw (4) has a
hole in the angle transmission (3) and rotate
the blade (1) by hand until the wrench enters
the inner hole, blocking rotation.