GGP ITALY SPA 325 Manual De Instrucciones página 34

10
EN
IMPORTANT
To avoid breaking the star-
ter rope, do not pull the whole length of it or let
it slide along the edge of the cable guide hole.
Release the starter gradually, to avoid letting it fly
back uncontrollably.
7. Pull the starter rope again until the engine
starts as normal.
WARNING!
Starting the engine with
the starter engaged causes the cutting de-
vice to move, only stopping when the starter
is disconnected.
8. When the engine is started, disconnect the
starter by turning the lever (2) to «RUN».
9. Let the engine run idle for at least 1 minute
before using the machine.
IMPORTANT
If the starter rope is pulled
repeatedly with the choke on, it may flood the
engine and make starting difficult.
If you have flooded the engine, remove the spark
plug and gently pull the handle on the starter
rope to eliminate any excess fuel; then dry the
spark plug electrodes and replace it on the
engine.
• Hot starting
When hot starting (immediately after stopping
the engine), follow the procedure indicated
above in points 1 - 5 - 6 - 7.
USE OF THE ENGINE (Fig. 7)
Cutting device speed is regulated by the throttle
trigger (2), located on the rear handgrip (4) or the
right handgrip (4a) of the handlebar.
The throttle trigger only works if the lockout (3) is
pressed at the same time.
The movement is transmitted from the engine to
the drive shaft by a centrifugal mass clutch that
prevents the shaft from moving when the engine
is running at minimum speed.
All manuals and user guides at all-guides.com
the cutting device moves when the engine is
running idle; in this case, contact you dealer.
The correct running speed will be achieved by
pressing the throttle trigger (2) as far as possible.
full power for the first 6-8 working hours.
STOPPING THE ENGINE (Fig. 7)
To stop the engine:
– Release the throttle trigger (2) and allow the
– Set the switch (1) to «STOP».
speed to a minimum, it will take a few sec-
onds for the cutting device to stop
HOW TO START - USE - STOP THE ENGINE
WARNING!
Do not use the machine if
IMPORTANT
Avoid using the engine at
engine to run idle for a few seconds.
WARNING!
When you have reduced