Fastening To The Floor; Assembling The Accessories Support - Sicam SBM 55S NW Manual Original

en 38 | SBM 55S NW | Commissioning
4.1.2

Fastening to the floor

1. Hoist the SBM 55S NW with a crane. Erect in the in-
tended area, taking care to comply with the specified
minimum distances.
i
To ensure reliable, ergonomic use of the
SBM 55S NW, we advise setting it up at a distance of
500 mm from the nearest wall.
651076-10_Im
500 mm
1005 mm
Warning – Risk of tipping
Considerable forces are involved in the wheel
balancing process.
¶
The device must be secured to the floor
before using it, following the steps indica-
ted by the manufacturer.
¶
A bumpy bottom or subject to vibrations
can lead to inaccuracies in measuring the
imbalance.
2. Place the SBM 55S NW on the floor in its final provi-
ded position and take the references of the holes on
the base of the machine.
3. Fit the drill with a 14 mm bit and drill 65 mm deep
holes.
|
1 695 656 114 2012-03-28
!
Accurately clean the hole before inserting the plug..
4. Insert the provided plugs, interpose the washers and
tighten with a torque wrench and fastening torque
25 Nm
500 mm
1000 mm
Fig. 5:
1 Fastening screws
2 Washer
3 Fischer
4.2
¶
Assemble the accessories supports on the machine
using the screws present on the casing, as shown in
the figure.
Warning – Risk of tipping
¶
The SBM 55S NW must be attached to the
floor in 3 points through screw-plug.
¶
Use bolt holes.
Fixation of SBM 55S NW

Assembling the accessories support

Sicam srl società unipersonale