Fixing Of Spring-Clip Weights; 35 8.8.2 Fixing The Adhesive Weights With; Electronic Calliper Gauge - Sicam SBM 55S NW Manual Original

8.6.3 Splitting the balancing weights (Split program)
i
The external weight hidden behind the spokes can
be applied for non-standard programs (ALU2, ALU3,
Pax2).
i
If the balancing weights must be fastened behind
one or two spokes, the Split program must be activa-
ted after the measurement.
1. Press the <SPLIT> button.
 The left display shows N and the right display
shows the currently set number of spokes.
 Both <SPLIT> button LEDs (Fig. 9, Item 3) light up.
2. Using the <-> or <+> keys for rim diameter, set the
correct number of spokes
 The value is shown in the right-hand display.
3. Turn the wheel until the spoke is in 12 o'clock positi-
on and press <SPLIT>.
 The spoke position is now
 Only one <SPLIT> button LED lights up.
 The value of the required balancing weight is
shown in the right-hand display.
4. Turn the wheel by hand.
 As soon as the position for attaching the balan-
cing weight is reached, the LED (Fig. 9, Item 2)
lights up. An acoustic signal confirms that the po-
sition is correct (behind a spoke).
5. Fasten the balancing weight with the required value
in the uppermost (12 o'clock) position of the wheel.
¶
When fastening adhesive weights with electronic
calliper gauge, see chap 8.8.1.
6. Continue turning the wheel manually to fix the other
balancing weight behind the spoke
 The other <SPLIT> button LED lights up.
 Repeat points 4 and 5.
i
To terminate the Split program and go back to
displaying only the balancing weight, press <SPLIT>
again.
Sicam srl società unipersonale
.
memorised.
Balancing a wheel | SBM 55S NW | 49
8.7

Fixing of spring-clip weights

i
Use the counterbalance clamp to position the spring-
clip weights.
Fig. 14: Counterbalance clamp
1 Bit for removing the spring-clip weight
2 Hammer for fixing the weight on the rim
3 Shear for cutting the adhesive weights
4 Undercut for crushing the spring-clip weight
5 Blade for scraping the adhesive weights
1. Once the correct position of the balancing counter-
balance is reached, rest the spring-clip weight on the
rim edge.
2. Fix the spring-clip weight on the rim using the
weight positioning clamp hammer (2).
!
Use the bit (1) of the weights positioning clamp to
remove the spring-clip weight.
8.8 Fixing the adhesive weights
i
Adhesive weight positioning is applied through:
$

electronic calliper gauge;

651076-36_Im
|
1 695 656 114 2012-03-28
en