Porter Cable PCB330BS Manual De Instrucciones página 5

1. TO AVOID INJURY from unexpected movement,
make sure the saw is on a firm, level surface and
properly secured to prevent rocking. Make sure
there is adequate space for operating. Bolt the saw
to a support surface to prevent slipping, walking or
sliding during operation.
2. UNPLUG AND TURN the saw off before moving it.
3. USE THE CORRECT size and style of blade.
4. USE blades rated at 2700 FPM or greater.
5. MAKE SURE the blade teeth point down and
towards the table when installed on unit.
6. BLADE GUIDES, SUPPORT BEARINGS AND
BLADE TENSION must be properly adjusted to
avoid accidental blade contact and to minimize
blade breakage. To maximize blade support, always
adjust the upper blade guide and blade guard so
that it is 1/8 inch (3.2 mm) above the workpiece.
7. TABLE LOCK HANDLE should be tight.
8. USE EXTRA CAUTION with large, very small or
awkward workpieces.
9. USE EXTRA SUPPORTS to prevent workpieces
from sliding off the table top. Never use another
person to support the workpiece.
10. WORKPIECES must be secured so they do not
twist, rock or slip while being cut.
11. PLAN intricate and small work carefully to avoid
pinching the blade. Avoid awkward operation and
hand positions to prevent accidental contact with
the blade.
12. SMALL PIECES should be secured with jigs or
fixtures. Do not hold pieces that are so small your
fingers are under the blade guard.
13. SUPPORT round work properly (with a V-block or
clamped to the miter gauge) to prevent it from rolling
and the blade from biting.
14. CUT only one workpiece at a time. Make sure the
table is clear of everything except the workpiece and
guides before turning the saw on.
15. ALWAYS WATCH the saw run before each use.
If there is excessive vibration or unusual noise, stop
immediately. Turn the saw off. Unplug immediately.
Do not start the saw again until the problem has
been located and corrected.
All manuals and user guides at all-guides.com
BAND SAW SAFETY
5
16. TO FREE any jammed material, turn the switch off.
Remove the switch key and unplug the saw.
Wait for all moving parts to stop before removing
jammed material.
17. DO NOT LEAVE the work area until all moving parts
are stopped. To childproof the workshop, shut off
power to master switches and remove the switch
key from the band saw. Store it in a safe place,
away from children.
WARNING
!
For your own safety, read the entire Instruction
Manual before using the band saw.
1. Wear eye protection.
2. Do not wear gloves, neckties or loose clothing.
3. Make sure the saw is on a firm level surface and
properly secured.
4. Use only the recommended accessories.
5. Use extra caution with very large, very small or
awkward workpieces.
6. Keep hands away from the blade at all times to
prevent accidental injury.
7. Do not remove jammed or cutoff pieces until the
blade has stopped.
8. Maintain proper adjustment of blade tension, blade
guides and thrust bearings.
9. Hold the workpiece firmly against the table.
10. Adjust the upper guide to clear the workpiece.