Washers - Porter Cable PCB330BS Manual De Instrucciones

7. Mount the door plate (12) to the R.H. side plate (3)
hinges and fasten with four screws w/ washers (10).
NOTE: Hinge goes behind side plate lip.
8. Place stand on level surface and adjust the feet if
needed.
Fig. A-5
12
NOTE: Make sure all screws and nuts are tight and stand
is on a stable surface before mounting saw.
WARNING
!
Although compact, this saw is heavy and should be
lifted with care. If needed, get the assistance of
someone to lift and move the saw.
ASSEMBLING BAND SAW TO CABINET STAND
(FIG. B)
1. Lift the saw body (1) and place on the stand (2),
aligning the mounting holes (3) of the saw base with
the four mounting holes on the top plate of stand.
2. Bag "D" - Attach the band saw to the stand with four
long hex head bolts (4) and four flat washers (5).
3. Place a flat washer (5) and hex nut (6) on each bolt
from the underside of the top plate.
4. Hold bolt head with a separate wrench and tighten all
mounting bolts and nuts with a wrench.
Fig. B
1
4
5
3
2
5
6
All manuals and user guides at all-guides.com
3
10
INSTALLING THE SAWDUST PORT (FIG. C )
The sawdust port has a 2-1/2 in.(63.5 mm, O.D.)/2-1/4
in.(57.2 mm, I.D.) diameter opening, suitable for attach-
ing to a wet/dry vacuum hose to help keep the work
area free of sawdust.
1. Open the lower cover (1).
2. Bag "E" - Attach the sawdust port (2) to the edge
of the wheel cover, using the hex head bolts (3) and

washers (4).

3. Tighten the bolts (3) and close the cover.
Fig. C
2
ASSEMBLING THE BAND SAW TABLE (FIG. D, E, F)
Mounting the trunnion support bracket (Fig. D)
1. Place the trunnion support bracket (1) on the saw
body as shown, then align the mounting holes.
2. Bag "F" - Place the washers (2) on the hex head
bolts (3), and insert into the threaded holes, through
the bracket and saw body. Tighten the bolts.
3. Thread a nut (4) into the table stop bolt (5) and the
rear tab (6) on the trunnion support bracket (1).
4. Tighten the nut down onto the bracket tab.
Fig. D
5
4
6
1
12
1
3
4
3
2