Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installing
1. Make sure the blade tension knob (1) is turned
counterclockwise enough to get blade over pulleys.
2. Remove old blade as explained in "Removing"
section.
3. Guide the new blade (7) through the table slot (11).
Make sure the blade teeth are pointing forward
and down.
NOTE: To avoid lifting the workpiece, the blade teeth
must point downward toward the table.
4. Swinging the left side of the blade away and back,
place the blade on the upper and lower wheels (10).
5. Place the blade carefully between the upper and
lower blade guides (8).
6. Slide the blade into the slot (9) at the left of the
wheels, and make sure the blade is positioned at the
middle of the wheels.
7. Turning the blade tension knob (1) clockwise, tighten
the tension until the blade is tight on the wheels.
8. Replace the upper blade guard (6) and tighten the
two Phillips screws (5).
9. Replace the table insert (2) and the table aligning
pin (3).
10.Adjust the blade tracking and tension properly
(See ADJUSTMENT INSTRUCTIONS section)
before operating the band saw.
WARNING
!
To avoid injury, the blade tension, tracking, and
upper and lower guides and bearings must be properly
adjusted before operating the band saw.
(See ADJUSTMENT INSTRUCTIONS section)
WARNING
!
Before operation always make sure the blade is in
center of table insert slot.
MITER GAUGE (FIG. H)
A miter gauge (1) is supplied with your band saw to be
used in the table slot (2) on the right side of the blade.
The miter gauge can be adjusted from 0
left to maintain an accurate angle for your workpiece.
Fig. H
1
2
All manuals and user guides at all-guides.com
to 60
right or
°
°
14
INSTALLING POWER CORD STORAGE (FIG. I)
1 . Bag "I" - Power cord brackets (1) are provided for
convenient cord storage. Attach the power cord
brackets to the back of the saw body, as shown, with
two Phillips head screws (2). Tighten the screws.
2. Wrap the power cord onto the brackets when the
band saw is not in use. This can prevent damage to
the cord.
Fig. I
ADJUSTMENT INSTRUCTIONS
WARNING
!
To avoid injury, turn the switch OFF and unplug the
band saw from the power source before making any
adjustments.
TABLE ADJUSTMENTS (FIG. J, K)
Tilting the table (Fig. J)
The band saw table (1) can be tilted from 0° to 45° right.
1. Loosen both table lock knobs (2) underneath
the table.
2. Tilt the table to the desired angle on the scale (3)
underneath the table.
3. Tighten the two table lock knobs.
Fig. J
1
2
0
2
1
2
3
Capítulos
Tabla de contenido
