Tabla de contenido
Idiomas disponibles
Idiomas disponibles
240 VOLT SINGLE PHRASE OPERATION
WARNING
!
To avoid injury, disconnect the motor from power
source outlet before reconnecting the wire.
The motor supplied with your machine is a dual voltage,
120/240 volt motor. It is shipped ready-to-run for 120 volt
operation. However, it can be converted for 240 volt op-
eration, reconnect the motor wire as the wiring diagram
on page 20.
A qualified electrician should do the conversion, or the
machine can be taken to an Authorized Service Center.
When completed, the machine must conform to the Na-
tional Electric Code and all local codes and ordinances.
The machine is converted by re-wiring the motor
for 240 volts, installing a 240 volt plug on the power
supply cord and replacing the switch with one that is
rated for 240 volt operation.
Be sure the 240 volt plug is only used in an outlet having
the same configuration as the plug illustrated in Fig. 1.
No adapter should be used with the 240 volt plug.
CAUTION
!
In all cases, make certain that the receptacle in question
is properly grounded. If you are not sure, have a quali-
fied electrician check the receptacle.
TOOLS NEEDED FOR ASSEMBLY
Supplied
Hex key
All manuals and user guides at all-guides.com
Not Supplied
Phillips screwdriver
Adjustable wrench
12 mm wrench
Combination square
Straight edge
Feeler gauge
(size 0.02 in.)
CARTON CONTENTS
UNPACKING AND CHECKING CONTENTS
Carefully unpack the band saw and all its parts, and
compare against the list below and the illustration on
the next page. With the help of an assistant place the
saw on a secure surface and examine it carefully.
WARNING
!
● To avoid injury from unexpected starting or electrical
shock, do not plug the power cord into a source of
power during unpacking and assembly. This cord
must remain unplugged whenever you are adjusting/
assembling the saw.
● The saw is heavy and should be lifted with care.
If needed, get the assistance of someone to lift and
move the saw.
● If any part is missing or damaged, do not attempt
to assemble the band saw, or plug in the power
cord until the missing or damaged part is correctly
replaced.
TABLE OF LOOSE PARTS
ITEM
DESCRIPTION
A.
Foot pads & hex nuts
B.
Bag:
Carriage screws
Hex nuts w/ washers
Screw w/ washers
C.
Door knob / hex screw / washer
D.
Stand attachment hardware
Large washers
Hex nuts
Long hex bolts
Hex bolts
F.
Trunnion support hardware
Long bolt
Short hex bolts
Table lock knob
G.
Trunnion support bracket
H.
Table with insert
I.
Power cord bracket
Cross head bolts
Hex key
J.
Band saw with motor
N.
Left / right side plate
O.
Back plate
7
QUANTITY
4
16
16
8
1 each
8
4
4
1
2
2
1
2
1
2
2
1
1
2
2
1
1
1
1
1
1 each
1
1
Capítulos
Tabla de contenido
