Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ADJUSTING THE 90
TABLE STOP (FIG. K)
°
1. Loosen the table lock knobs (1) and tilt the table to
the right.
2. Loosen the nut (2) on the table stop bolt (3) and
lower the stop bolt as far as possible.
3. Tilt the table until it rests on the stop bolt.
4. Place a combination square (4) on the table with the
heel of the square against the saw blade (5).
5. Adjust the tilt of the table left or right until it is 90° to
the blade. Make sure there is no space between the
square and the blade. Tighten the table lock knobs.
6. Adjust the table stop bolt up until it touches the table.
Tighten the jam nut down to the support bracket.
7. Loosen the lock knobs and see that the table is
resting on the stop bolt.
8. Check the square to make sure the table is still
square to the blade. If not, re-adjust the stop bolt.
9. When the adjustment is accurate at 90
pointer (6) to 0
on the scale (7).
°
Fig. K
4
7
0
6
BLADE TENSION
WARNING
!
To avoid injury, turn the switch OFF and disconnect the
saw from the power source before making any
adjustments. NEVER make tension adjustments with
the machine running.
Blade tension was set at the factory. When adjustment
is needed please follow the procedure below.
The gauge (1) on the bracket (2) at the rear of the upper
wheel indicates the proper tension for the various blade
widths.
1. Set the blade tension gauge (1) to correspond with
the blade width, as shown.
2. Turn the blade tension knob (3) clockwise to tighten
the blade, counterclockwise to loosen.
3. As you become familiar with the saw, you may try to
change the tension settings.
NOTE: Changes in blade width and type of material
being cut will have an effect on the blade tension.
Too much or too little tension could break the blade.
All manuals and user guides at all-guides.com
, align the
°
5
3
1 2
15
Fig. L
3
BLADE TRACKING (FIG. M)
WARNING
!
To avoid injury, turn the switch OFF and disconnect the
saw from the power source before making any
adjustments. NEVER make tracking adjustments with
the machine running.
Blade tracking was set at the factory. When adjustment
is needed please follow the procedure below.
1. The blade (1) must be tensioned properly before
adjusting the tracking. (See BLADE TENSION).
2. Open the upper cover.
3. Move the blade guides (2) and support bearings (3)
away from the blade, if necessary.
4. Rotate the wheel (4) slowly forward by hand, and
check the position of the blade on the wheel. The
blade should remain centered on the wheel as it
turns.
5. If the blade moves toward the front of the wheel, turn
the tracking knob (5) on the rear of the band saw
clockwise. This tilts the top of the wheel and moves
the blade toward the center.
6. If the blade moves toward the back edge, turn the
tracking knob counterclockwise, moving the blade
toward the center.
NOTE: Turn the tracking knob SLIGHTLY to make blade
tracking adjustments.
1
2
2
1
4
1
1
8
Capítulos
Tabla de contenido
