Installing And Removing Blades (Fig. G) - Porter Cable PCB330BS Manual De Instrucciones

Mounting the table (Fig. E, F)
5. Remove the table insert (13) from the table.
6. Guide the table slot (14) over the saw blade and
rotate a 1/4 turn, so the slot is perpendicular to
the blade.
7. Bag "F" - Placing the lock knob bolts (10) through
the trunnion bracket holes (15) as shown, lower the
table onto the trunnion bracket.
8. Place a lock knob (16) on each lock knob bolt.
Adjust the table by aligning the zero scale mark to
the scale pointer (17) and tighten the knobs.
9. Replace the table insert (13), aligning the indents.
10.Place the table aligning pin (18) in the hole (19) at
the front of the table, and tighten it.
Fig. E
13
Fig. F
16
All manuals and user guides at all-guides.com
14
10
15
19
13
18
17

INSTALLING AND REMOVING BLADES (FIG. G)

WARNING
!
To avoid injury from accidental starting, always turn the
switch OFF and remove the plug from the power source
before moving, replacing, or adjusting the blade.
Removing
1. Loosen the blade tension by turning the blade tension
knob (1) counterclockwise.
2. Remove the table insert (2) and remove the table
aligning pin (3) from the table.
3. Open the upper and lower wheel cover doors (4).
4. Loosen the two Phillips screws (5) and remove the
upper blade guard (6).
5. Remove the blade (7) from the upper and lower blade
guides (8).
6. Carefully pull the blade from the side slot (9) and
from the wheels (10).
7. Swing the left side of the blade toward you, turning
the blade so it will fit through the slot (11) in the table,
and remove.
NOTE: The available usage of blade length is from
91-1/2 to 93-1/2 in. (2324 to 2374.9 mm).
Fig. G
4
4
13
1
10
6
5
8
9
7
2
8
10
11
3