Display; On/Off Battery Led Light; On/Off Power Supply Management; Packing And Handling - CAMPAGNOLA COBRA PRO Manual De Uso Y Mantenimiento

4.1.3

Display

After quickly pressing the ON/OFF button (11) on the display (9), the charge level will be visible for about 5 seconds with
the following representations:
• 4 led bars – 80/100% charge level
• 3 led bars – 60/80% charge level
• 2 led bars – 40/60% charge level
• 1 led bar – 20/40% charge level
• 1 flashing led light – charge level is lower than 20%
• All flashing led lights with repetition each second – Error status .
If any undervoltage is detected, it persists even if the battery is switched off and then on again, until it reaches at least the
20% of its status of charge (SoC).
WARNING!
If the problem cannot be solved, take the battery to an Authorized Service Point.
4.1.4

ON/OFF battery led light

When the button is pressed while switching off the battery, the timed lit-up led bars quantity will decrease up to zero.
When the last LED bar is off, the battery switches off by releasing the button.
4.1.5

ON/OFF power supply management

•
When the battery is off, it is switched on by pressing the button. The charge level can be seen for 5 seconds.
•
When the battery is off, it is switched on by connecting it to the charger. The charge level can be seen on as long as
the charger is connected.
•
If the consumption is less than 200 mA, the self-switching-off timer is activated. Timing depends on the battery pack
status of charge (SoC).
•
The operator can switch off the battery by keeping the button pressed for at least 5 seconds.
•
The battery switches off automatically, when the charger is disconnected or when charge is complete
•
While the battery is charging, it cannot be switched off.
WARNING!
When not used, recharge the battery in June and in December.
At the end of the pruning season, recharge the battery completely before storing it.
Failure to comply with these indications could irreparably damage the battery pack.
WARNING!
Never work on trees or ladders, since it is extremely dangerous.
Before starting any task with the tool, wear protective clothes. Check that all the safety and protection devices
can perfectly work and have been exactly assembled.
4.2

Packing and handling

The unit is packaged by Campagnola S.r.l and shipped to the dealer in a case.
WARNING!
The handling of loads must be carried out in compliance with the current safety rules in the workplace.
Use and Maintenance Manual – Original
Instructions Rev.: 00, Date 10/10/2018
Pag. 29