Technical Data; Safety Devices; Installation; Start-Up - CAMPAGNOLA COBRA PRO Manual De Uso Y Mantenimiento

3.6

Technical data

- PONY PRO Shear cutting diameter
- COBRA PRO Shear cutting diameter
- Weight of PONY PRO Shear
- Weight of COBRA PRO Shear
- Weight of PONY PRO Shear with battery, display and backpack
- Weight of COBRA PRO Shear with battery, display and backpack
- Battery weight (without electronic control unit)
- Battery weight (with electronic control unit)
- Battery pack
- Battery autonomy
- Battery charger
3.7

Safety devices

Automatic switch-off of the system: if not used for over 20 minutes and the charge ˃ 20% or not used for 5 minutes and
the charge is ˂ 20%, the shear switches off. It is turned back on by pressing the button (11).
Trigger guard (20): prevents accidental activation of the trigger (15).
Automatic switch-off of the shear: if not used for over 5 minutes (SAFE function). It turns back on by pressing the trigger
(15) 2-3 times.
Switching off the shear: Keep the trigger (15) pressed >5 seconds (STOP function). It turns back on by pressing the trig-
ger (15) 2-3 times. LED (16) on shear: indicates whether the shear is on or off.

4 INSTALLATION

4.1

Start-up

•
Recharge the battery (1) with the battery charger (34) (see paragraph 5.3).
•
Apply the battery (1) to the backpack (4) following the instructions indicated below.
•
Apply the display (10) to the belt of the backpack (4) (right or left)
•
Connect the display (10) to the battery pack (1) by means of the connector (7) passing the cord through the loops (27).
•
Connect the shear to the battery pack (1) by means of the connector (6) passing the cord through the loops (27).
4.1.1

Installation of battery and components on backpack

•
Remove the backpack (4) and the battery (1) from the case.
•
Recharge the battery (1) with the battery charger (34) (see paragraph 5.3).
•
Insert the bracket (32) in the window of the backpack (4) (picture G).
•
Insert the belt through the loop (33) at the top of the battery (1) (picture F).
IMPORTANT!
If the backpack (4) is fitted properly, the connector of the battery charger (8) can be accessed without removing
the battery pack (1).
4.1.2

Left side shear operation configuration

The battery pack is supplied with a shell for the electronic control unit (21) set for right side shear operation. To invert the
electronic control unit shell (21), proceed as follows:
- Unscrew the two screws (35).
- Turn the shell of the electronic control unit (21) 180° without this disconnecting the internal cord.
- Tighten the two screws (35) repositioning the bracket (32) at the back of the battery (1).
Pag. 28
25 mm
40 mm
0.900 kg (with cord) - 0.760 kg (cordless)
1.000 kg (with cord) - 0.910 kg (cordless)
3.230 kg
3.310 kg
1.2 kg
1.37 kg
Li-Ion
8 / 9 h
Output 58.8V - DC 2.0A
Use and Maintenance Manual – Original
Instructions Rev.: 00, Date 10/10/2018