Tabla de contenido
132 |
Replacing the heating elements of electric ovens
Disconnect the switch upstream of the appliance so that
the unit will be disconnected from the mains. In the FE
oven, the lower heating elements are positioned under the
bottom and the upper heating elements are positioned on
the upper side of the cooking chamber. In the FE1 oven,
the heating element is positioned behind the conveyor on
the rear of the cooking chamber. To remove the heating
elements, loosen the screws fixing them; pay attention
to the connection leads. Use a screwdriver to disconnect
the connection leads and mount a new heating element
following the sequence in reverse.
LONG PERIODS OF APPLIANCE INACTIVITY
If the appliance is not used for long periods of time, please
EN
WARRANTY CERTIFICATE
COMPANY NAME:
ADDRESS:
____________________________________________________________________________________________________
POSTAL CODE :
__________
PROVINCE:
_______________
ATTENTION!
The manufacturer declines all responsibility for any inaccuracies in this handbook due to typing or printing errors.
The manufacturer reserves the right to make any changes that may be required without altering the basic features of the
product. The manufacturer declines all responsibility in the event that the instructions given in this handbook are not fully
observed. The manufacturer declines all responsibility for any direct or indirect damage caused by incorrect installation,
tampering, poor maintenance and negligent use.
____________________________________________________________________________________________
TOWN:
___________________________________________________________________________
INSTALLATION DATE:
MODEL.
_________________________________________
PART NUMBER:
observe the following:
1) Switch of the disconnecting switch to disconnect unit
from the mains
2) Clean the equipment and the surrounding areas
properly
3) Pour a small quantity of cooking oil on the stainless
steel surfaces
4) Carry out all maintenance operations
5) Cover the appliance with a suitable material and leave
a few openings to allow air to circulate.
WHAT TO DO IN THE EVENT OF A FAILURE
In the event of a failure, immediately disconnect the unit
from the mains and call for the Technical Assistance.
____________________________________________________________
________________________________
Tabla de contenido
