Tabla de contenido
128 |
Error
Insufficient heating of cooking zone
Continuous heating of cooking zone at maximum power
The cooking zone starts up when there isn't a pan in place
Small metal objects are heated up
The cooking zone doesn't get warm
No reaction from the appliance
Fuses blown when the unit is switched on
The cooking zones don't get warm
Error code pattern
Faults can be detected according to the duration and frequency of the green light blinking. The blinking gives an error
EN
code pattern. The green lamp blinking one (E1) or two (E2) long flashes and than short regular flashes according to the
specific error number. This pattern is constantly repeated.
For example: error code E1 06:
Long
1
2 3
For example: error code E2 03:
Long
Long
Error messages from the generator
Error No.
Fault
E1 01
Electrical overloading
E1 02
No power in the inductor
E1 03
The IGBT temperature is too high
E1 04
The cooking zone temperature is too high
or too low
E1 05
Failure of the control unit
E1 06
The internal temperature is too high
E1 07
Cooking zone temperature sensor
E1 08
Mains phase failure
TROUBLESHOOTING
SERIES 900 INDUCTION HOBS
Cause
The pan is made of an unsuitable material
The knob switch is broken
The pan detection sensor is faulty
The pan detection sensor is faulty
The diameter of the pan bottom is less than
12 cm
Mains fuse / main supply interrupted
Short-circuit in generator
The generator is faulty
4 5
6
Long
1
2
3 4
1
2 3
Long
Long
1
2 3
Cause
Unsuitable pan or wrong or faulty coil
Inductor connection failure
Air intakes are blocked.
The fan is clogged. The temperature sensor
is broken
The pan is empty; the temperature sensor
is faulty
The control unit is defective or wiring is
defective
Air intakes are blocked.
The fan is clogged. The temperature sensor
is broken. The unit is too close to other
heat sources
The temperature sensor of the coils is short
circuited
Breakdown of the mains phase or mains
phase or mains synchronization
Solution
Use a suitable pan
Check / replace the knob switch
Replace the generator / have it repaired
Replace the generator / have it repaired
Use a suitable pan
Check mains connection
Replace the generator / have it repaired
Replace the generator / have it repaired
5 6
Solution
Use a suitable pan, check the coil
Connect the inductor properly
Clear the air intakes.
Clean fan. Check the fan rotation
Remove the pan, switch off the unit
and wait until the cooking plate has
cooled down; check the operation of the
temperature sensor
Check or replace the operating unit;
check the unit's wiring harness
Clear the air intakes.
Clean fan.
Keep the unit away. from other heat
sources.
Lower the ambient temperature.
Replace / check the temperature sensor
Check mains supply
Tabla de contenido
