Tabla de contenido
ATTENTION!
Please refer to the initial pages of this manual for the figures mentioned in this chapter.
APPLIANCE DESCRIPTION
Sturdy stainless steel structure with 4 legs (adjustable in
height).
Oven chamber made in stainless steel with glass wool
insulation.
The double-lined, heat insulated door has a handle and a
hinge with a balanced spring.
Cooking tops with electric plates made of cast iron,
infrared tops and glass ceramic induction plates.
Control knobs made in synthetic material, automatic or
manual safety devices with manual or self reset, 7-position
switches and dual circuit power regulators.
Legal and technical requisites
The manufacturer declares that the appliances are made
in conformity with the EEC directives and requires that
the installation is performed in accordance with the
regulations in force.
During the assembly, the following requisites should be
adhered to:
- building regulations and local fire prevention
provisions
- health and safety regulations
- current CEI regulations
- current Fire Brigade regulations
INSTALLATION
Handling and transportation
The units are placed on wooden pallets to facilitate
transportation and handling by a forklift or trolley either
on the premises or when they are loaded and unloaded.
Units are packed in 3-layer sturdy cardboard boxes with
stickers and prints applied onto them for providing advice
relevant to handling. The symbols give information about
their handling, forbid the lifting the units with hooks and
storing outdoors.
It also warns operators that the packaging contains fragile
objects and indicates the vertical position that the box
must keep. It also directs the operator on opening the
packaging from downwards to upwards.
Before beginning the installation, remove the packaging.
A few parts are protected with an adhesive film, which
should be removed carefully.
Remove any glue residual with the proper substances,
such as petrol; never use abrasive substances.
INSTALLATION INSTRUCTIONS
MOD.
V
kW:
Mount the unit legs; the unit must be leveled; small
differences of height can be solved by adjusting the legs.
The main switch or the socket must be close to the unit
and easy to reach.
We recommend placing the unit under a suction hood so
that vapor can quickly evacuate.
Room ventilation
The room where the appliance is installed must be fitted
with air intakes to guarantee the correct operation of the
unit and air exchange. The air intakes must be of adequate
dimensions, be protected by grids and be positioned free
of any obstruction. (See Fig. 2 – Fig. 3).
Caution - Warning
Do not install the appliance near any other units
that can reach high temperatures: the electrical
components might be damaged. During installation,
make sure that the air suction and the means of
evacuation are free of any obstacles.
The installation, start-up and maintenance of the unit
must be performed by qualified personnel. All installation
operations must be carried out in conformity with the
regulations in force. The manufacturer declines all liabilities
in the event that the unit works incorrectly because of an
incorrect installation or because it does not comply with
the regulations in force.
Install the appliances, keeping it a distance of more than
20 cm from the side walls (see Fig. 1).
The appliances equipped with a connection terminal
board on their side should be installed at a distance of
more than 50 cm from the side wall. The models equipped
with the connection terminal board on their back should
be installed at a distance of more than 50 cm from the
wall.
"In any case the unit must be installed/fixed in order it
is possible to replace the power supply cable after the
unit is installed".
N°:
Hz: 50/60
IPX4
INSTALLATION
| 123
EN
Tabla de contenido
