HURAKAN HKN-ISE10 Manual Del Usuario página 19

1. Place the pedal on a dry surface.
2. Connect the power.
3. Set the direction switch to the UP position so that the piston rises to the top.
4. Tilt the cylinder and fill it with minced meat.
5. Place the cylinder back inside the barrel.
6.
Set the DIRECTION switch to the DOWN position and press the stand pedal so that the
piston begins to lower.
7. If the piston moves too fast or too slowly, use the speed switch (handle) to adjust the
speed.
8. When you fill the casing, take your foot off the pedal and the piston will stop.
9. When the piston reaches the bottom of the cylinder, the device will automatically
stop. Now set the DIRECTION switch to the UP position so that the piston goes up.
10. If necessary, repeat the procedure starting with step 4.
1. Disconnect the device from the mains before cleaning.
2. Remove the cylinder, piston and forming tube. Wash by hand in soapy water and dry
thoroughly.
3. Wipe the device with a damp cloth.
USAGE
CARE
EN
19