Checking After Installation; When Removing The Ceiling Panel For Servicing; Adjusting The Auto Flap - Sanyo SPWXDR124GH56A Manual Del Usuario

9-5. Checking After Installation

●
Check that there are no gaps between the unit and
the ceiling panel, or between the ceiling panel and
the ceiling surface.
Gaps may cause water leakage and condensation.
●
Check that the wiring is securely connected.
If it is not securely connected, the auto flap will not
operate. ("P09" is displayed on the remote control-
ler.) In addition, water leakage and condensation
may occur.
9-6. When Removing the Ceiling Panel for
Servicing

When removing the ceiling panel for servicing,

remove the air-intake grille and air filter, disconnect
the wiring connector inside the electrical component
box, and then remove the 4 mounting screws.

9-7. Adjusting the Auto Flap

The air-direction louver on the ceiling panel outlet can
be adjusted as follows.
●
Adjust the louver to the desired angle using the
remote controller. The louver also has an automatic
air-sweeping mechanism.
NOTE
●
Never attempt to move the louver by hand.
●
Proper air flow depends on the location of the air
conditioner, the layout of the room and furniture,
etc. If cooling or heating seems inadequate, try
changing the direction of the air flow.
DC̲Inverter̲Eng.indd 65 DC̲Inverter̲Eng.indd 65
65
GB
FR
DE
IT
PT
GR
ES
2007/07/25 13:21:48 2007/07/25 13:21:48