Installing The Remote Controller - Sanyo SPWXDR124GH56A Manual Del Usuario

Installing the Remote Controller

●
If the remote controller is to be installed onto a wall or other surface for use, first place the remote controller in
the location where it will be installed and press
at the indoor unit and that the A/C begins operating.
GB
FR
Installation screws
Truss tapping
4 16
DE
IT
●
Installing the batteries
PT
(1) Press on both sides of the remote controller cover
and slide it downward to remove it.
(2) Insert 2 AAA alkaline batteries. (Pay attention to
the + and – directions.)
GR
(3) Use an object with a sharp point to press the ACL
(ALL CLEAR) button, then reattach the cover.
(Be sure to press the ACL (ALL CLEAR) button
after replacing the batteries.)
ES
Precautions for remote controller installation
●
Before mounting the remote controller on the wall, place the unit at the mounting position, then turn on any fluo-
rescent lamps, press the ON/OFF button, and check that the air conditioner operates correctly.
When using the remote controller to detect the room temperature, observe the following precautions during instal-
lation:
• Avoid locations where the remote controller will be exposed to the direct path of air blown from the air conditioner.
• Avoid locations where the remote controller will be exposed to direct sunlight.
• Avoid locations where the remote controller will be exposed to direct heat sources.
DC̲Inverter̲Eng.indd 102 DC̲Inverter̲Eng.indd 102
(ON / OFF). Confirm that the "signal-received" sound occurs
Place in holder
1
Press
2
Fig. 10-29
To remove the remote controller, pull it toward you.
102
Fig. 10-30
2007/07/25 13:21:54 2007/07/25 13:21:54