Tabla de contenido
●
For flush mounting into a wall, install the separate
receiver unit in a metal switch box (field supply)
that has been recessed into the wall in advance.
1. Insert a flathead screwdriver or similar tool into the
notch, and remove the face plate.
2. Fix the receiver unit with 2 M4 screws provided.
Do not overly tighten, and use the provided
spacers. If the receiver unit does not fit in the wall,
cut spacers to adjust the clearance.
3. Connect the receiver unit wiring (2-core cable)
with the cables extended from the indoor unit.
(Refer to the section on receiver unit wiring.)
Be sure to determine the correct terminal numbers
on the indoor unit when wiring the receiver unit.
The remote controller will be damaged if high
voltage (such as 220 – 240 V AC) is applied.
4.
Reinstall the face plate.
●
When using exposed mounting for the receiver unit,
install onto a wall where the receiver unit can be
attached.
1. Insert a flathead screwdriver or similar tool into the
groove on the bottom of the receiver unit. Pry open
with the screwdriver and remove the lower case.
(Fig. 11-14)
2. In order to later pass the receiver wiring out
through the upper case (thin part at the top
center), use nippers or a similar tool to cut a notch
in the same size as the remote controller cord
(optional). (Fig. 11-15)
3. Disconnect the wires that were connected to the
connector at the time of shipment.
4. Fasten the remote controller cord (optional) at the
position shown in Fig. 11-16, using the provided
clamper. Then connect the cord to the receiver
connector.
5. Shape the remote controller cord as shown in Fig.
11-16 so that it fits at the top inside the receiver
unit, above the PCB. Then attach the lower case.
At this time, bend the head of the clamp so that it
faces sideways.
6. Remove the nameplate and use 2 wood screws to
attach the receiver unit.
7. Use the provided cord clips to fasten the remote
controller cord to the wall.
8. Reattach the nameplate.
DC̲Inverter̲Eng.indd 111
DC̲Inverter̲Eng.indd 111
Face plate
Fig. 11-14
Notch where remote
controller cord passes
through top case
Fig. 11-15
Remote controller cord
(optional)
Clamp
Fig. 11-16
111
Clamp
2 3 mm
Connector
Remote controller
cord (optional)
Wood
Receiver unit
screws (2)
1
2
3
4
5
6
2007/07/25 13:21:56
2007/07/25 13:21:56
GB
FR
DE
IT
PT
GR
ES
Tabla de contenido
