MN007262A01-AD
Chapter 4: Installation Details for Standard Configurations
4.2
Radio Mounting
CAUTION:
Do not mount the radio on a plastic dashboard without first reinforcing the dashboard; the
weight of the radio may crack or break the dashboard.
Do not mount the radio on a flat or concave surface where the radio could be partially
submersed in water. This is especially important if the cab area of the vehicle is cleaned by
spraying with water. If the radio sits in water for a length of time, moisture may seep inside the
radio and damage the electronic components.
Do not allow water to stand in recessed areas of vertically mounted radios. Remove any
moisture immediately to prevent it from seeping down into the radio.
The mounting location must be accessible and visible. Select a location that permits routing the RF
antenna cable as directly as possible.
For new or existing installations, use one of the mounting kits as specified in table below. Orient the
mounting trunnion.
Mounting Kit
Low Profile Trunnion Kit
Standard Profile Trunnion Kit
Key Lock Trunnion Kit
DIN Mount
Figure 8: Trunnion Orientation for Above or Below Mobile
1
Label
1
4.2.1
Dash Mount with Trunnion
Procedure:
1 Select the location to mount your radio on the transmission hump or under the dash.
NOTICE: When mounting the trunnion on the transmission hump take care that the
transmission housing is not affected.
16
Motorola Solutions Part Number
RLN6466_
RLN6467_
RLN6468_
FTN6083_
Description
Radio Front